Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM2040EQ _59 Vehicle Exterior _014733 WINDOW / GLASS _0075142 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The power window regulator motor assembly (for driver door) is operated by the power window regulator master switch assembly. The power window regulator motor assembly (for driver door) has motor, regulator and ECU functions.

When the ECU determines that the power window regulator motor assembly (for driver door) has not been initialized, DTC B2313 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2313 Glass Position Initialization Incomplete
·

Power window regulator motor assembly not initialized

·

Power window regulator motor assembly malfunctions

·

Auxiliary battery disconnected when power switch on (IG)


·

Power window regulator motor assembly (for driver door) not initialized

·

Power window regulator motor assembly (for driver door)



CAUTION / NOTICE / HINT

NOTICE:
·

DTC B2313 can be stored in the power window regulator motor assembly (for driver door).

·

When disconnecting the auxiliary battery while the power switch is on (IG), DTC B2313 is stored.

·

If a power window regulator motor assembly (for driver door) has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).



PROCEDURE

1.PERFORM INITIALIZATION (DRIVER DOOR WINDOW)
a.

Initialize the power window regulator motor assembly (for driver door).

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Turn the power switch off.


b.

Wait for at least 10 seconds, and then turn the power switch on (IG).


c.

Check for DTCs.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR

Body Electrical > D-Door Motor > Trouble Codes
50001 124
OK:

B2313 output does not recur.



Result:
Proceed to
OK
NG



OK

END (PROBLEM DUE TO INITIALIZATION FAILURE)

NG

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR)