The power window regulator motor assembly (for driver door) is operated by the power window regulator master switch assembly. The power window regulator motor assembly (for driver door) has motor, regulator and ECU functions.
This DTC is stored when the power window regulator motor assembly (for driver door) has a malfunction, or the ECU built into the regulator motor assembly determines that the fully closed window position has deviated approximately 20 mm (0.787 in.) or more from the normal position.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2311 | Power Window Motor Malfunction | Either condition is met: 1.
Power window regulator motor assembly malfunctions 2.
When ECU in power window regulator motor assembly determines that fully closed window position has deviated approx. 20 mm (0.787 in.) or more from normal position |
·
Power window regulator motor assembly (for driver door) ·
Incorrect installation of power window components ·
Overheated power window regulator motor assembly |
DTC B2311 can be stored in the power window regulator motor assembly (for driver door).
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
If a power window regulator motor assembly (for driver door) and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / D-Door Motor / Active Test.
Perform the Active Test according to the display on the intelligent tester.
Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power Window | Power window | OFF / UP / DOWN | - |
| Tester Display |
|---|
| Power Window |
Driver door power window motor operates.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Initialize the power window regulator motor assembly (for driver door).
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Check that the driver door power window operates normally by opening and closing the window.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Driver door power window operates normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check that the power window components are installed correctly.
Power window components are installed correctly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the power switch off.
Wait for at least 10 seconds, and then turn the power switch on (IG).
Check for DTCs.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>DTC CHECK / CLEAR
B2311 output does not recur.
| Proceed to |
|---|
| OK |
| NG |
OK
NG