When a key switch is pushed: 1) the door control receiver receives the wireless door lock signal; 2) the door control receiver sends a signal to the main body ECU (multiplex network body ECU) through the certification ECU (smart key ECU assembly); 3) the main body ECU (multiplex network body ECU) sends the operation permission signal to the power window regulator motor assembly (for driver door); and 4) the power window regulator motor assembly (for driver door) is activated.
When the driver door key cylinder (key linked switch) is turned: 1) the door lock motor receives the signal; 2) the main body ECU (multiplex network body ECU) sends the signal to the power window regulator motor assembly (for driver door); and 3) the power window regulator motor assembly (for driver door) is activated.
This function is set through the customize function, as it is off by default.
The power window control system uses a LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Check that the wireless door lock/unlock function operates normally.
Click hereVehicle Interior>DOOR LOCK>WIRELESS DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
Check that the key-linked lock/unlock function operates normally.
Click hereVehicle Interior>DOOR LOCK>POWER DOOR LOCK CONTROL SYSTEM>OPERATION CHECK
| Result | Proceed to |
|---|---|
| Wireless door lock/unlock function and key-linked lock/unlock function operate normally | A |
| Wireless door lock/unlock function does not operate normally | B |
| Key-linked lock/unlock function does not operate normally | C |
A
B
C
Check that the manual up and down functions using the power window regulator master switch assembly can operate the driver door power window.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Manual up and down functions are normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG