The combination meter assembly receives the hazard switch ON signal and controls the operation of the hazard warning lights.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Data List.
Read the display on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Hazard Flasher Switch | Hazard switch signal | ON or OFF | ON: Hazard switch on
OFF: Hazard switch off |
- |
| Tester Display |
|---|
| Hazard Flasher Switch |
Normal conditions listed above are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the air conditioning control assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>HAZARD WARNING SWITCH>REMOVAL
| *a | Component without harness connected
(Air Conditioning Control Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 4 (HAZ) - 6 (GND) | Hazard switch on | Below 1 Ω |
| 4 (HAZ) - 6 (GND) | Hazard switch off | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I17 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I56-4 (HAZ) - I17-5 (HAZ) | Always | Below 1 Ω |
| I56-4 (HAZ) - Body ground | Always | 10 kΩ or higher |
| I56-6 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG