1. PRECAUTION (w/ Navigation System)
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER (w/ Navigation System)
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Navigation System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.REMOVE REAR CONSOLE BOX ASSEMBLY
5.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55660
6.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
58916
7.REMOVE BOX BOTTOM MAT
58804A
8.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
9.REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)
10.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)
86211
11.REMOVE NO. 1 RADIO BRACKET (w/o Navigation System)
86212
12.REMOVE NO. 2 RADIO BRACKET (w/o Navigation System)
86211J
13.REMOVE NO. 1 RADIO RECEIVER BRACKET (w/ Navigation System)
86212C
14.REMOVE NO. 2 RADIO RECEIVER BRACKET (w/ Navigation System)
55900
15.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Disengage the 4 clips and guide, and remove the air conditioning control assembly as shown in the illustration.