75740
1.INSTALL REAR DOOR BELT MOULDING ASSEMBLY
Engage the 6 claws to install the rear door belt moulding assembly as shown in the illustration.
68104
2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
68124B
3.INSTALL REAR DOOR QUARTER WINDOW GLASS
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67408F
4.INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
68152C
5.INSTALL REAR DOOR GLASS RUN
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67872
6.INSTALL REAR DOOR WEATHERSTRIP
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
68640A
7.INSTALL REAR DOOR CHECK ASSEMBLY
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67842E
8.INSTALL REAR DOOR SERVICE HOLE COVER
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
68174A
9.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
67604
10.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
74260
11.INSTALL REAR ARMREST ASSEMBLY
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
12.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
69284D
13.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
Use the same procedure for the RH side and LH side.
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
14.CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
64718C
15.INSTALL LUGGAGE TRIM SERVICE HOLE COVER
16.INSPECT POWER WINDOW OPERATION