Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR DOOR WINDOW FRAME MOULDING › 2012.02–2015.04
RM2040EQ _59 Vehicle Exterior _014740 EXTERIOR PANELS / TRIM _0075197 REAR DOOR WINDOW FRAME MOULDING A

EXTERIOR PANELS / TRIM  REAR DOOR WINDOW FRAME MOULDING  REMOVAL  


PROCEDURE

Hide 75740 1.REMOVE REAR DOOR BELT MOULDING ASSEMBLY

Hide 75762A 2.REMOVE REAR DOOR FRONT WINDOW FRAME MOULDING

HINT:

When removing the rear door front window frame moulding, heat the vehicle body and rear door front window frame moulding using a heat light.


Heating Temperature
Item Temperature
Vehicle Body 40 to 60°C (104 to 140°F)
Moulding 20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the vehicle body or moulding excessively.


a.

Using a heat light, heat the rear door front window frame moulding.


b.
B280093C07
1.396,1.177 1.656,1.396 false 2.031,1.677 1.802,1.823 false 1.469,2.552 1.479,3 1.479,3 1.625,2.563 false 1.229,1.083 1.552,1.385 0.323,0.302 10 false *1 2.052,1.583 2.406,1.938 0.354,0.354 10 false *1 1.385,3.01 1.74,3.24 0.354,0.229 10 false *2
*1 Double-sided Tape
*2 Caulking Sponge


Using a moulding remover, disengage the clip and remove the rear door front window frame moulding.


Hide 75764A 3.REMOVE REAR DOOR UPPER WINDOW FRAME MOULDING

a.

Insert a 4.0 mm (0.157 in.) drill bit into a drill.


b.
B280098E02
2.583,3.948 2.885,4.177 0.302,0.229 10 false A

Tape a 4.0 mm (0.157 in.) drill bit 5.0 mm (0.197 in.) from the tip as shown in the illustration.

Area Dimension
A 5.0 mm

NOTICE:

Tape the 4.0 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.



c.

Lightly press the drill bit against the rivets to drill off the rivet flanges, and remove the 6 rivets.

NOTICE:
·

Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

·

Prying the rivets with the drill may damage the rivet installation holes or drill bit.

·

Be careful of the drilled rivets, as they may be hot.




d.

Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled areas.


e.

Disengage the guide, remove the rear door upper window frame moulding from the door frame.