The accumulator pressure sensor is built into the brake actuator (brake booster with master cylinder assembly).
The skid control ECU detects the accumulator pressure from the data sent from the accumulator pressure sensor, and then starts and stops the pump motor by operating the motor relay.
This DTC may be stored if the accumulator pressure drops due to frequent braking (this is not a malfunction).
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1365/54 | Accumulator Pressure Sensor Malfunction | 331
332 333 334 |
·
INF Code: 331 ·
Sensor supply voltage (VACC) is 4.54 V or less, or 5.46 V or more for 0.8 seconds or more. ·
INF Code: 332 ·
Accumulator pressure sensor output voltage (PACC) is less than 8%, or 88% or more of sensor supply voltage for 0.8 seconds or more (less than 0.4 V, or 4.4 V or more for 0.8 seconds or more). ·
INF Code: 333 ·
Fluctuation of sensor output is out of specification (the difference between the present value and last value is 7.5 MPa (77.0 kgf/cm2, 1088 psi)) for 0.8 seconds or more. ·
INF Code: 334 ·
At a vehicle speed of 6 km/h (4 mph) or more and accumulator pressure sensor output value of 19.7 MPa (200.8 kgf/cm2, 2857 psi) or less, the pump motor does not operate for 12 seconds or more. |
Brake booster with master cylinder assembly | Electronically controlled brake system DTC |
When replacing the skid control ECU (brake booster with master cylinder assembly) or brake actuator (brake booster with master cylinder assembly), perform initialization and calibration of the linear solenoid valve.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Select the Data List on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Accumulator Sensor | Accumulator pressure sensor | Min.: 0.00 V, Max.: 5.00 V | Specified value: 2.90 to 4.20 V | When brake fluid is stored in the accumulator: Accumulator pressure changes in accordance with volume of fluid stored in the accumulator |
| Tester Display |
|---|
| Accumulator Sensor |
Wait for 30 seconds without depressing the brake pedal.
Check that the accumulator pressure sensor output value change is within the specified range.
Accumulator pressure sensor output value change is less than 0.55 V.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Turn the power switch off.
Clear the DTCs.
Perform a road test.
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C1365/54 is not output. | A |
| DTC C1365/54 is output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B