The combination meter assembly communicates with the ECM or power management control ECU, skid control ECU, power steering ECU assembly, main body ECU (multiplex network body ECU), and airbag sensor assembly via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with ECM or power management control ECU continues for 2 seconds or more |
·
ECM ·
Power management control ECU ·
CAN communication system ·
Combination meter assembly |
| U0129 | Lost Communication with Skid Control ECU | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with skid control ECU continues for 2 seconds or more |
·
Skid control ECU ·
CAN communication system ·
Combination meter assembly |
| U0131 | Lost Communication with Power Steering Control Module | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with power steering ECU assembly continues for 3 seconds or more |
·
Power steering ECU assembly ·
CAN communication system ·
Combination meter assembly |
| U0142 | Lost Communication with Main Body ECU | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with main body ECU (multiplex network body ECU) continues for 3 seconds or more |
·
Main body ECU (Multiplex network body ECU) ·
CAN communication system ·
Combination meter assembly |
| U0151 | Lost Communication with Airbag ECU | When IG voltage is 9.5 V or more and the following condition is detected:
1.
No communication with airbag sensor assembly continues for 10 seconds or more |
·
Airbag sensor assembly ·
CAN communication system ·
Combination meter assembly |
Check if CAN communication system DTCs are output
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTCs are output. | A |
| DTCs are not output. | B |
If CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 first.
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING