Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075024 PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)  C1694  Steering Angle Initialization Incomplete  


DESCRIPTION

This DTC is stored when the navigation ECU sub-assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1694 Steering Angle Initialization Incomplete Maximum steering angle has not been memorized
·

Steering angle setting

·

Navigation ECU sub-assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)>CALIBRATION



PROCEDURE

1.PERFORM SETTINGS
a.

Perform the following to steering angle setting into the navigation ECU sub-assembly.



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
Result:
Result Proceed to
DTC C1694 is output A
DTCs are not output B


HINT:
·

If DTC C1694 is output, perform the steering angle setting again.

·

If DTC C1694 is still output after performing the steering angle setting 3 times, replace the navigation ECU sub-assembly.





A

B

END