Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075026 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABA  Blind Spot Monitor Slave Module Connection Incorrect  


DESCRIPTION

The blind spot monitor sensor LH stores this DTC when terminal No. 3 of the blind spot monitor sensor LH is not connected properly, or the blind spot monitor sensor is not installed on its correct side and the wire harness that is connected to the blind spot monitor main switch (warning canceling switch assembly) is connected to terminal No. 3 of the blind spot sensor LH.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1ABA Blind Spot Monitor Slave Module Connection Incorrect There is an open in the ground circuit (Terminal No. 3) of the blind spot monitor sensor LH for a specified period of time.
·

Wire harness or connector

·

Blind spot monitor sensor LH



WIRING DIAGRAM

E224406E06
2.25,2.49 2.688,2.667 0.438,0.177 10 false LGND 2.729,2.375 2.844,2.542 0.115,0.167 10 false 3 1.698,3.229 2.375,3.615 0.677,0.385 10 false T10 1.698,3.406 2.854,3.875 1.156,0.469 10 false Blind Spot Monitor Sensor LH 4.552,3.208 4.948,3.365 0.396,0.156 10 false O28 4.552,3.385 5.76,3.719 1.208,0.333 10 false Blind Spot Monitor Sensor RH 1,4.281 3.365,4.469 2.365,0.188 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

After completing this procedure, make sure to clear the DTC.


·

When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.



PROCEDURE

1.CONFIRM PART NUMBER AND IDENTIFICATION MARK
a.

Confirm whether the blind spot monitor sensors are installed to the correct side or not.

i.

Check if the part number and identification mark of the blind spot monitor sensor on the vehicle is correct.

OK:

The part number and identification mark is correct.




Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR

NG

INSTALL BLIND SPOT MONITOR SENSOR TO CORRECT SIDE

2.CHECK HARNESS AND CONNECTOR
a.

Disconnect connector T10 from the blind spot monitor sensor LH.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
T10-3 (LGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T10-3 (LGND) - Body ground Power switch on (IG) Below 1 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR