If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.
If a short is detected in a speaker circuit, no sound can be heard from the speakers.
Disconnect the connectors from the stereo component amplifier assembly and speakers.
Measure the resistance between each of the front No. 1 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I68-15 (FR+) - J5-1 | Always | Below 1 Ω |
| I68-30 (FR-) - J5-2 | Always | Below 1 Ω |
| I68-11 (FL+) - K5-1 | Always | Below 1 Ω |
| I68-26 (FL-) - K5-2 | Always | Below 1 Ω |
Measure the resistance between each of the front No. 2 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I68-12 (TWR+) - I84-4 | Always | Below 1 Ω |
| I68-27 (TWR-) - I84-3 | Always | Below 1 Ω |
| I68-14 (TWL+) - I2-4 | Always | Below 1 Ω |
| I68-29 (TWL-) - I2-3 | Always | Below 1 Ω |
Measure the resistance between the front No. 3 speaker assembly and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I68-13 (CTR+) - I60-2 | Always | Below 1 Ω |
| I68-28 (CTR-) - I60-1 | Always | Below 1 Ω |
Measure the resistance between each of the rear No. 2 speaker assemblies and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I68-10 (SR+) - O19-2 | Always | Below 1 Ω |
| I68-25 (SR-) - O19-1 | Always | Below 1 Ω |
| I68-9 (SL+) - O20-2 | Always | Below 1 Ω |
| I68-24 (SL-) - O20-1 | Always | Below 1 Ω |
Measure the resistance between the rear speaker assembly and the stereo component amplifier assembly to check for an open circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I68-8 (WF1+) - O22-1 | Always | Below 1 Ω |
| I68-23 (WF1-) - O22-2 | Always | Below 1 Ω |
Measure the resistance between the stereo component amplifier assembly and body ground to check for a short circuit in the wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I68-15 (FR+) - Body ground | Always | 10 kΩ or higher |
| I68-30 (FR-) - Body ground | Always | 10 kΩ or higher |
| I68-11 (FL+) - Body ground | Always | 10 kΩ or higher |
| I68-26 (FL-) - Body ground | Always | 10 kΩ or higher |
| I68-12 (TWR+) - Body ground | Always | 10 kΩ or higher |
| I68-27 (TWR-) - Body ground | Always | 10 kΩ or higher |
| I68-14 (TWL+) - Body ground | Always | 10 kΩ or higher |
| I68-29 (TWL-) - Body ground | Always | 10 kΩ or higher |
| I68-13 (CTR+) - Body ground | Always | 10 kΩ or higher |
| I68-28 (CTR-) - Body ground | Always | 10 kΩ or higher |
| I68-10 (SR+) - Body ground | Always | 10 kΩ or higher |
| I68-25 (SR-) - Body ground | Always | 10 kΩ or higher |
| I68-9 (SL+) - Body ground | Always | 10 kΩ or higher |
| I68-24 (SL-) - Body ground | Always | 10 kΩ or higher |
| I68-8 (WF1+) - Body ground | Always | 10 kΩ or higher |
| I68-23 (WF1-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected
(Front No. 1 Speaker Assembly) |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J5-1 - J5-2 | Always | 4.6 to 6.6 Ω |
| K5-1 - K5-2 | Always | 4.6 to 6.6 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected
(Front No. 2 Speaker Assembly) |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I84-4 - I84-3 | Always | 3.4 to 5.2 Ω |
| I2-4 - I2-3 | Always | 3.4 to 5.2 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Front No. 3 Speaker Assembly) |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I60-1 - I60-2 | Always | 6.8 to 10.2 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *A | for RH |
| *B | for LH |
| *a | Component without harness connected
(Rear No. 2 Speaker Assembly) |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O19-1 - O19-2 | Always | 6.8 to 10.2 Ω |
| O20-1 - O20-2 | Always | 6.8 to 10.2 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Rear Speaker Assembly) |
Resistance check
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O22-1 - O22-2 | Always | 4.8 to 6.8 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG