Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for HDD) › 2012.02–2015.04
RM2040EQ _56 Audio / Visual / Telematics _014717 NAVIGATION / MULTI INFO DISPLAY _0078805 NAVIGATION SYSTEM(for HDD) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for HDD)  B15F7  Certification ECU Vehicle Information Reading/Writing Process Malfunction  


DESCRIPTION

This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.

HINT:

The certification ECU (smart key ECU assembly) controls the smart entry and start system (for Entry Function) related items that are customizable via the multi-display screen.


DTC No. Detection Item DTC Detection Condition Trouble Area
B15F7 Certification ECU Vehicle Information Reading/Writing Process Malfunction Certification ECU (smart key ECU assembly) vehicle setting processing error.
·

CAN communication system

·

Smart entry and start system (for Entry Function)

·

Certification ECU (smart key ECU assembly)

·

Navigation ECU sub-assembly



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Use the intelligent tester to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

OK:

CAN communication DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.CHECK SMART ENTRY AND START SYSTEM (for Entry Function)

NG

2.CHECK SMART ENTRY AND START SYSTEM (for Entry Function)
a.

Check if the smart entry and start system (for Entry Function) is malfunctioning.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SMART ENTRY AND START SYSTEM(for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING

HINT:

Customization may not be possible depending on the malfunction in the smart entry and start system (for Entry Function).


OK:

No malfunctions are present in the smart entry and start system (for Entry Function).



Result:
Proceed to
OK
NG



OK

3.CHECK CUSTOMIZE ITEMS

NG

3.CHECK CUSTOMIZE ITEMS
a.

Display the "Door lock settings" screen.


b.

Make a note of the customizable items for each certification ECU related system.

HINT:

These items shown as customizable via the navigation system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.


i.

Check the customize parameters list for the smart entry and start system (for Entry Function) related items that can be customized via the multi-display screen.

Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SMART ENTRY AND START SYSTEM(for Entry Function)>CUSTOMIZE PARAMETERS



c.

Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the multi-display screen.

OK:

The items available for customization via the multi-display screen can be customized successfully using the manual procedure.



Result:
Proceed to
OK
NG



OK

NG

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)