Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM2040EQ _58 Vehicle Interior _014730 HEATING / AIR CONDITIONING _0075108 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1446/46  Air Mix Damper Control Servo Motor Circuit (Driver Side)  


DESCRIPTION

The No. 1 air conditioning radiator damper servo sub-assembly (air mix for driver side) sends pulse signals to inform the air conditioning amplifier assembly of the damper position. The air conditioning amplifier assembly activates the motor (normal or reverse) based on the signals to move the No. 1 air conditioning radiator damper servo sub-assembly (air mix for driver side) to any position. As a result, the amount of air passing through the heater core after passing through the evaporator is adjusted, and the temperature of the air blowing toward the driver seat side is controlled.

The air conditioning amplifier assembly communicates with the servo through a communication/driver IC and wiring assembly called the air conditioning harness assembly.


DTC No. Detection Item DTC Detection Condition Trouble Area Memory
B1446/46 Air Mix Damper Control Servo Motor Circuit (Driver Side) Air mix damper position sensor value does not change even though air conditioning amplifier assembly operates No. 1 air conditioning radiator damper servo sub-assembly (air mix for driver side)
·

No. 1 air conditioning radiator damper servo sub-assembly (air mix for driver side)

·

Air conditioning harness assembly

·

Air conditioning amplifier assembly


Memorized
(30 sec. or more)*1

*1: The air conditioning amplifier assembly stores the DTC of the respective malfunction if it has occurred for the period of time indicated in the brackets.


WIRING DIAGRAM

E265642
5.781,2.396 6.552,2.594 0.771,0.198 10 false BUS 5.802,3.333 6.573,3.531 0.771,0.198 10 false BUS G 5.781,1.448 6.552,1.646 0.771,0.198 10 false B BUS 5.594,1.323 5.833,1.573 0.24,0.25 10 false 4 5.583,2.281 5.823,2.531 0.24,0.25 10 false 3 5.583,3.229 5.823,3.479 0.24,0.25 10 false 2 5.417,4.24 6.188,4.438 0.771,0.198 10 false z1 0.156,4.26 2.563,4.885 2.406,0.625 10 false No. 2 Air Conditioning Radiator Damper Servo Sub-assembly (Air Mix for Front Passenger Side) 2.938,4.271 4.49,4.729 1.552,0.458 10 false Air Conditioning Harness Assembly 5.406,4.417 6.948,4.844 1.542,0.427 10 false Air Conditioning Amplifier Assembly

CAUTION / NOTICE / HINT

HINT:

Confirm that no mechanical problem is present because this diagnostic code can be stored when either a damper link or the damper is mechanically locked.


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Operate the driver side temperature adjustment switch.


e.

Enter the following menus: Body / Air Conditioner / Data List.


f.

Check the value(s) by referring to the table below.

Body Electrical > Air Conditioner > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Air Mix Servo Actual Pulse(D) No. 1 air conditioning radiator damper servo sub-assembly (air mix for driver side) actual pulse Min.: 0, Max.: 255 MAX COLD: 105
MAX HOT: 7
-
Body Electrical > Air Conditioner > Data List
Tester Display
Air Mix Servo Actual Pulse(D)
50003 121 128
OK:

The display is as specified in the normal condition column.



Result:
Result Proceed to
NG A
OK (When troubleshooting according to Problem Symptoms Table) B
OK (When troubleshooting according to the DTC) C



A

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER

B

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

C

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

2.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Air Conditioner / Active Test.


e.

Check the operation by referring to the table below.

Body Electrical > Air Conditioner > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Air Mix Servo Targ Pulse(D) No. 1 air conditioning radiator damper servo sub-assembly (air mix for driver side) pulse Min.: 0, Max.: 255 Operates between 7 and 105 pulses
Body Electrical > Air Conditioner > Active Test
Tester Display
Air Mix Servo Targ Pulse(D)
50004 121 24
OK:

Air temperature changes in accordance with each control range.



Result:
Proceed to
OK
NG



OK

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

NG

3.REPLACE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (AIR MIX FOR DRIVER SIDE)
3.REPLACE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (AIR MIX FOR DRIVER SIDE)
a.

Replace the No. 1 air conditioning radiator damper servo sub-assembly (air mix for driver side).

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the servo motor cannot be inspected while it is removed from the vehicle, replace the servo motor with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1446/46 is output A
DTC B1446/46 is not output B




A

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY

B

END (NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (AIR MIX FOR DRIVER SIDE) WAS DEFECTIVE)

4.REPLACE AIR CONDITIONING HARNESS ASSEMBLY
a.

Replace the air conditioning harness assembly.

Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>DISASSEMBLY

HINT:

Since the air conditioning harness assembly cannot be inspected while it is removed from the vehicle, replace the air conditioning harness assembly with a new or known good one and check that the condition returns to normal.



b.

Check for the DTC.

Body Electrical > Air Conditioner > Trouble Codes
50001 121
Result:
Result Proceed to
DTC B1446/46 is output A
DTC B1446/46 is not output B




A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

END (AIR CONDITIONING HARNESS ASSEMBLY WAS DEFECTIVE)