Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Rear Side) › from 2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0075030 ULTRASONIC SENSOR(for Rear Side) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear Side)  INSTALLATION  


PROCEDURE

Hide 89348 1.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

HINT:

Use the same procedure for all No. 1 ultrasonic sensor retainers.


a.
E301652C01
1.073,1.865 1.333,1.573 false 2.146,1.969 2.406,1.677 false 2.073,1.948 2.385,2.104 0.313,0.156 10 false *a 0.969,1.885 1.281,2.042 0.313,0.156 10 false *b
*a Cutout
*b Protrusion


Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the rear bumper assembly.

NOTICE:
·

Do not damage the rear bumper assembly with the protrusion when installing the No. 1 ultrasonic sensor retainer.

·

Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the No. 1 ultrasonic sensor retainer and surface of the rear bumper assembly.



HINT:
·

When installing the retainer, align the cutout and protrusion as shown in the illustration.


·

This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.




Hide 89341A 2.INSTALL NO. 1 ULTRASONIC SENSOR

HINT:

Use the same procedure for all No. 1 ultrasonic sensors.


a.

Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

NOTICE:

Push the No. 1 ultrasonic sensor retainer from the outside of the rear bumper assembly when there is a gap between the No. 1 ultrasonic sensor retainer and the rear bumper assembly surface. In this case, do not push on the No. 1 ultrasonic sensor.



Hide 89348J 3.INSTALL ULTRASONIC SENSOR CLIP

HINT:

Use the same procedure for all ultrasonic sensor clips.


a.

Engage the 4 claws to install the ultrasonic sensor clip.


Hide 4.INSTALL NO. 2 LUGGAGE ROOM WIRE

HINT:

Use the same procedure for all connectors.


a.

Connect the connector to install the No. 2 luggage room wire.


b.

Engage the clamp.


Hide 5.INSTALL REAR BUMPER ASSEMBLY