Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.
1.REMOVE REAR BUMPER ASSEMBLY
2.REMOVE BLIND SPOT MONITOR SENSOR LH WITH COVER
Disconnect the connector.
Remove the 3 nuts to remove the blind spot monitor sensor LH with cover.
3.REMOVE BLIND SPOT MONITOR SENSOR RH WITH COVER
Disconnect the connector.
Remove the 3 nuts to remove the blind spot monitor sensor RH with cover.
88173
4.REMOVE BLIND SPOT MONITOR COVER LH
Disengage the 3 claws to remove the blind spot monitor cover LH.
88163
5.REMOVE BLIND SPOT MONITOR COVER RH
Disengage the 3 claws to remove the blind spot monitor cover RH.
88162
6.REMOVE BLIND SPOT MONITOR SENSOR LH
88162
7.REMOVE BLIND SPOT MONITOR SENSOR RH