Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014700 CRUISE CONTROL _0166042 DYNAMIC RADAR CRUISE CONTROL SYSTEM J

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM  Cruise SET Indicator Light Circuit  


DESCRIPTION

·

The driving support ECU assembly turns on the cruise control SET indicator light by sending indicator output demand signals to the combination meter assembly via CAN communication.

·

The cruise control SET indicator light illuminates when the dynamic radar cruise control system is controlling vehicle speed.

·

The cruise control SET indicator light circuit uses CAN communication. If the cruise control SET indicator light is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

·

When replacing the combination meter assembly, make sure to replace it with a new one.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS (METER DISPLAY 1)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Meter Display 1 Multi-information display OFF or All -
Body Electrical > Combination Meter > Active Test
Tester Display
Meter Display 1
50004 122 7

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. B



A

2.READ VALUE USING GTS (SET/COAST SWITCH)

B

2.READ VALUE USING GTS (SET/COAST SWITCH)
a.

Enter the following menus: Powertrain / Radar Cruise / Data List.


b.

Read the Data List according to the display on the GTS.

Powertrain > Radar Cruise > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
SET/COAST Switch -/SET switch signal ON or OFF ON: -/SET switch on
OFF: -/SET switch off
-
Powertrain > Radar Cruise > Data List
Tester Display
SET/COAST Switch
50003 197 3

Result:
Result Proceed to
The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-/SET switch). A
The cruise control SET indicator does not illuminate but the Data List item SET/COAST Switch changes according to the operation of the cruise control main switch (-/SET switch). B
The cruise control SET indicator does not illuminate and the Data List item SET/COAST Switch does not change according to the operation of the cruise control main switch (-/SET switch). C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C

REPLACE DRIVING SUPPORT ECU ASSEMBLY