1. PRECAUTION
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.REMOVE REAR CONSOLE BOX ASSEMBLY
58916
5.REMOVE BOX BOTTOM MAT
58804A
6.REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
7.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
55660
8.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY
9.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY
|
Protective Tape |
Apply protective tape to the area shown in the illustration.
Remove the 4 bolts.
Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.
Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.
86211
10.REMOVE NO. 1 RADIO BRACKET
Remove the 5 screws and No. 1 radio bracket.
86212
11.REMOVE NO. 2 RADIO BRACKET
Remove the 5 screws and No. 2 radio bracket.
55900
12.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
86120L
13.REMOVE NAVIGATION RECEIVER ASSEMBLY