Home › Engine / Hybrid System › 2AR-FXE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › from 2015.04
RM2040EQ _51 Engine / Hybrid System _014691 2AR-FXE ENGINE CONTROL _0074877 CAMSHAFT POSITION SENSOR A

2AR-FXE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11102A 1.INSTALL CAMSHAFT POSITION SENSOR

a.
A158220

Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

NOTICE:

If reusing the camshaft position sensor, be sure to inspect the O-ring.



b.

Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

If the camshaft position sensor has been struck or dropped, replace it.

·

Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.




c.

Connect the camshaft position sensor connector.


Hide 2.INSPECT FOR OIL LEAK

Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY