This DTC is stored if the rear television camera assembly judges as a result of its self check that the signals or signal lines between the rear television camera assembly and navigation receiver assembly are not normal.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1621 | Back Camera Power Supply Failure | Rear television camera assembly power supply failure | ·
Harness or connector ·
Rear television camera assembly ·
Navigation receiver assembly |
If the cable was disconnected from and reconnected to the negative (-) auxiliary battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Disconnect the I174 navigation receiver assembly connector.
Disconnect the T22 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I174-11 (CA+) - T22-6 (CB+) | Always | Below 1 Ω |
| I174-23 (CGND) - T22-5 (CGND) | Always | Below 1 Ω |
| I174-11 (CA+) - I174-23 (CGND) | Always | 10 kΩ or higher |
| I174-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| I174-23 (CGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the I174 navigation receiver assembly connector.
| *a | Component with harness connected
(Navigation receiver Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I174-11 (CA+) - Body ground | Power switch on (ACC) | 5.5 to 7.05 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER(for SD)>REMOVAL