Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) › from 2015.04
RM2040EQ _56 Audio / Visual / Telematics _014718 PARK ASSIST / MONITORING _0169417 TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type) C

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)  C1AEC  Front Sensor Communication Malfunction  


DESCRIPTION

This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the ECU, or when there is a malfunction in a front sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AEC Front Sensor Communication Malfunction An open or short circuit in the communication line between the front sensors and ECU or a malfunction in a front sensor during initialization mode after the power switch is turned on (IG).
·

Front ultrasonic sensor circuit

·

Harness or connector

·

Clearance warning ECU assembly



WIRING DIAGRAM

E231492E48
0.292,1.948 1.781,2.635 1.49,0.688 10 false No. 1 Ultrasonic Sensor (Front Right Sensor) 2.938,1.948 4.406,2.458 1.469,0.51 10 false No. 1 Ultrasonic Sensor (Front Left Sensor) 5.677,1.927 6.875,2.365 1.198,0.438 10 false Clearance Warning ECU Assembly 0.292,1.792 0.771,2.021 0.479,0.229 10 false A79 2.938,1.771 3.292,2.094 0.354,0.323 10 false A77 5.667,1.781 6.052,2.042 0.385,0.26 10 false I82 1.219,0.51 1.625,0.865 0.406,0.354 10 false BI 1.219,1.406 1.583,1.76 0.365,0.354 10 false EI 1.219,0.948 1.458,1.135 0.24,0.188 10 false SI 3.854,0.51 4.344,0.833 0.49,0.323 10 false BI 3.854,1.406 4.24,1.688 0.385,0.281 10 false EI 3.854,0.958 4.198,1.24 0.344,0.281 10 false SI 3.167,0.49 3.594,0.792 0.427,0.302 10 false BO 3.177,1.417 3.615,1.729 0.438,0.313 10 false EO 3.177,0.938 3.563,1.24 0.385,0.302 10 false SO 5.854,0.5 6.198,0.646 0.344,0.146 10 false BOF 5.854,1.417 6.24,1.677 0.385,0.26 10 false E5 5.854,0.948 6.448,1.24 0.594,0.292 10 false SOF 1.469,0.375 1.76,0.656 0.292,0.281 10 false 1 1.469,0.833 1.708,1.135 0.24,0.302 10 false 3 1.469,1.302 1.75,1.563 0.281,0.26 10 false 5 4.156,0.375 4.396,0.688 0.24,0.313 10 false 1 4.156,0.844 4.385,1.167 0.229,0.323 10 false 3 4.156,1.292 4.5,1.615 0.344,0.323 10 false 5 2.958,0.385 3.188,0.625 0.229,0.24 10 false 2 2.958,0.844 3.219,1.135 0.26,0.292 10 false 4 2.958,1.292 3.271,1.552 0.313,0.26 10 false 6 5.615,0.385 5.948,0.719 0.333,0.333 10 false 4 5.615,0.844 5.917,1.177 0.302,0.333 10 false 8 5.615,1.281 5.917,1.583 0.302,0.302 10 false 6

PROCEDURE

1.CHECK DTC OUTPUT (C1AEC)
a.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Clear DTCs
50002 170

c.

Recheck for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AEC is output A
No DTCs are output B



A

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - FRONT LEFT SENSOR)

B

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - FRONT LEFT SENSOR)
a.

Disconnect the I82 clearance warning ECU assembly connector.


b.

Disconnect the A77 No. 1 ultrasonic sensor connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I82-4 (BOF) - A77-1 (BI) Always Below 1 Ω
I82-8 (SOF) - A77-3 (SI) Always Below 1 Ω
I82-6 (E5) - A77-5 (EI) Always Below 1 Ω
I82-4 (BOF) - Body ground Always 10 kΩ or higher
I82-8 (SOF) - Body ground Always 10 kΩ or higher
I82-6 (E5) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (FRONT LEFT SENSOR - FRONT RIGHT SENSOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (FRONT LEFT SENSOR - FRONT RIGHT SENSOR)
a.

Disconnect the A79 No. 1 ultrasonic sensor connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A77-2 (BO) - A79-1 (BI) Always Below 1 Ω
A77-4 (SO) - A79-3 (SI) Always Below 1 Ω
A77-6 (EO) - A79-5 (EI) Always Below 1 Ω
A77-2 (BO) - Body ground Always 10 kΩ or higher
A77-4 (SO) - Body ground Always 10 kΩ or higher
A77-6 (EO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)
a.
E227022C03
1.427,0.479 1.427,1.083 false 1.823,0.479 1.823,1.083 false 2.208,0.479 2.208,1.083 false 1.219,1.198 1.219,1.802 false 1.625,1.198 1.625,1.802 false 2.021,1.198 2.021,1.802 false 1.333,0.271 1.719,0.563 0.385,0.292 10 EI 2.115,0.271 2.479,0.615 0.365,0.344 10 BI 1.708,0.271 2.125,0.583 0.417,0.313 10 SI 1.125,1.833 1.604,2.146 0.479,0.313 10 EO 1.906,1.833 2.323,2.042 0.417,0.208 10 BO 1.5,1.833 1.99,2.073 0.49,0.24 10 SO 0.146,0.104 0.479,0.604 0.333,0.5 10 *a
*a Component without harness connected
(No. 1 Ultrasonic Sensor (Front Left Sensor))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (BI) - 5 (EI) Always 10 kΩ or higher
1 (BI) - 2 (BO) Always 10 kΩ or higher
3 (SI) - 4 (SO) Always Below 1 Ω
5 (EI) - 6 (EO) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

5.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)

NG

REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)

5.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT LEFT SENSOR)

NEXT

6.CHECK DTC OUTPUT (C1AEC)
6.CHECK DTC OUTPUT (C1AEC)
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Clear DTCs
50002 170

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AEC is output A
No DTCs are output B



A

7.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT RIGHT SENSOR)

B

END (FRONT LEFT SENSOR WAS DEFECTIVE)

7.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT RIGHT SENSOR)

NEXT

8.CHECK DTC OUTPUT (C1AEC)
8.CHECK DTC OUTPUT (C1AEC)
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Clear DTCs
50002 170

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TOYOTA PARKING ASSIST-SENSOR SYSTEM(for 4 Sensor Type)>DTC CHECK / CLEAR

Body Electrical > Clearance Sonar > Trouble Codes
50001 170

Result:
Result Proceed to
DTC C1AEC is output A
No DTCs are output B



A

B

END (FRONT RIGHT SENSOR WAS DEFECTIVE)