1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
64718C
2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER
3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67913
4.REMOVE FRONT DOOR SCUFF PLATE RH
62111A
5.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
62311B
6.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
55317A
7.REMOVE INSTRUMENT SIDE PANEL RH
53921B
8.REMOVE FRONT PANEL GARNISH RH
55431B
9.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL
53601
10.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
55432D
11.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL ASSEMBLY
73900
12.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
82877
13.REMOVE ECU INTEGRATION BOX RH
Disconnect each connector.
Remove the bolt, 2 nuts and ECU integration box RH.
89340A
14.REMOVE CLEARANCE WARNING ECU ASSEMBLY
Disengage the 2 claws and remove the clearance warning ECU assembly.