These DTCs are stored when a malfunction occurs in the navigation receiver assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1550 | DAB Tuner Malfunction | When any of the following conditions is met:
·
DAB tuner decoder malfunction ·
DAB tuner audio output section malfunction ·
DAB tuner decoder RF/IF malfunction ·
DAB tuner control communication error ·
DAB tuner OFDM error ·
DAB tuner memory error |
Navigation receiver assembly |
| B15A0 | LAN Master Malfunction | When either of the following conditions is met:
·
Bus malfunction ·
EEPROM error |
Navigation receiver assembly |
| B15AD | Navigation Processor Malfunction | When any of the following conditions is met:
·
Short to ground or +B or open occurs in gyro signal circuit ·
Gyro sensor malfunction ·
GPS receiver malfunction |
Navigation receiver assembly |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit) malfunction | Navigation receiver assembly |
| B15B3 | Radio Tuner Malfunction | When any of the following conditions is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
Navigation receiver assembly |
| B15B4 | CD Changer Malfunction | When any of the following conditions is met:
·
Mechanism drive signal malfunction ·
Load/Eject malfunction ·
Read mechanism malfunction ·
Mechanical malfunction |
Navigation receiver assembly |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Navigation receiver assembly |
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION RECEIVER(for SD)>REMOVAL