Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for SD) › from 2014.05
RM2040EQ _56 Audio / Visual / Telematics _014717 NAVIGATION / MULTI INFO DISPLAY _0169499 NAVIGATION SYSTEM(for SD) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for SD)  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

The navigation receiver assembly and roof console box assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.

This DTC is stored when a microphone connection detection signal line is disconnected.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1579 Voice Recognition Microphone Disconnected Microphone signal is lost.
·

Roof console box assembly

·

Telephone microphone assembly

·

Navigation receiver assembly

·

Harness or connector



WIRING DIAGRAM

E306886E06
0.406,2.052 2.896,2.552 2.49,0.5 10 false Roof Console Box Assembly (Telephone Microphone Assembly) 4.729,2.063 6.885,2.615 2.156,0.552 10 false Navigation Receiver Assembly 0.417,1.865 0.875,2.271 0.458,0.406 10 false S12 1.688,1.49 2.146,1.896 0.458,0.406 10 false MCO- 1.677,0.698 2.135,1.104 0.458,0.406 10 false SNS2 2.146,0.615 2.604,1.021 0.458,0.406 10 false 15 2.146,1.396 2.604,1.802 0.458,0.406 10 false 12 5.125,0.698 5.583,1.104 0.458,0.406 10 false SNS2 5.135,1.5 5.594,1.906 0.458,0.406 10 false MIN- 4.833,1.385 5.292,1.792 0.458,0.406 10 false 19 4.896,0.604 5.354,1.01 0.458,0.406 10 false 6 4.729,1.896 5.188,2.302 0.458,0.406 10 false I67

PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY
a.
E289390C09
1.427,0.656 1.802,0.896 0.375,0.24 2.073,2 2.354,2.677 false 0.125,0.115 0.438,0.313 0.313,0.198 10 false *a 1.521,0.688 1.833,0.885 0.313,0.198 10 false I67 2.427,2.625 2.938,2.885 0.51,0.26 10 false MIN-
*a Component with harness connected
(Navigation Receiver Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I67-19 (MIN-) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))

NG

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
a.

Disconnect the I67 navigation receiver assembly connector.


b.

Disconnect the S12 roof console box assembly (telephone microphone assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I67-6 (SNS2) - S12-15 (SNS2) Always Below 1 Ω
I67-19 (MIN-) - S12-12 (MCO-) Always Below 1 Ω
I67-6 (SNS2) - Body ground Always 10 kΩ or higher
I67-19 (MIN-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)
a.

Remove the roof console box assembly (telephone microphone assembly).

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.
E187117C48
2.313,1.719 2.104,1.354 false 1.688,1.729 1.771,1.365 false 2.281,1.75 2.698,1.958 0.417,0.208 10 false MCO- 1.385,1.76 1.802,1.958 0.417,0.198 10 false SNS2 0.156,0.156 0.469,0.354 0.313,0.198 10 false *a
*a Component without harness connected
(Roof Console Box Assembly (Telephone Microphone Assembly))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
15 (SNS2) - 12 (MCO-) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

4.REPLACE TELEPHONE MICROPHONE ASSEMBLY
4.REPLACE TELEPHONE MICROPHONE ASSEMBLY
a.

Replace the telephone microphone assembly with a new or known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE ROOF CONSOLE BOX ASSEMBLY