Home › General › INTRODUCTION › REPAIR INSTRUCTION › from 2015.04
RM2040EQ _V1 General _014687 INTRODUCTION _0074765 REPAIR INSTRUCTION D

INTRODUCTION  REPAIR INSTRUCTION  INITIALIZATION  


PROCEDURES NECESSARY WHEN AUXILIARY BATTERY TERMINAL IS DISCONNECTED/RECONNECTED


Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed See page
Correct the steering angle neutral point Parking assist monitor system (w/o Parallel Parking Assist Function) (Click here)

NOTICE:
·

After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal. (for Radio and Display Type)

·

After the ignition switch is turned off, the navigation receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 90 seconds before disconnecting the cable from the negative (-) battery terminal. (for Navigation Receiver Type)




PROCEDURES NECESSARY WHEN ECU OR OTHER PARTS ARE REPLACED


Replacement Part Necessary Procedure Effect/Inoperative Function when Necessary Procedures are not Performed See page
ECM Perform Vehicle Identification Number (VIN) or frame number registration
·

MIL illuminates

·

DTC P0630 is output


(Click here)
·

Throttle with motor body assembly

·

Cleaning the deposits from the throttle with motor body assembly

·

Engine assembly

·

Cylinder head sub-assembly

·

Camshaft

(for intake or exhaust camshaft)

·

Camshaft timing gear assembly

·

Piston or piston ring

·

Mass air flow meter sub-assembly

·

Fuel injector assembly

·

Fuel pump

·

Air fuel ratio sensor

·

Engine coolant temperature sensor

·

Spark plug

·

Ignition coil assembly

·

EGR valve assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly
·

Dynamic radar cruise control system

·

Pre-crash safety system


(Click here)
Lane departure warning camera Adjust lane departure warning camera Lane departure alert system (Click here)
Brake booster with master cylinder assembly
·

Initialization and calibration of the linear solenoid valve

·

Yaw rate and acceleration sensor zero point calibration


·

ABS warning light illumination

·

Brake warning light/yellow (minor malfunction) illumination

·

Slip indicator light illumination

·

VSC disable or malfunctioning


(Click here)for Initialization
(Click here)for Calibration
·

Brake pedal stroke sensor assembly

·

Brake pedal


·

Clearing stored linear solenoid valve calibration data

·

Initialization and calibration of the linear solenoid valve


Yaw rate and acceleration sensor (Airbag sensor assembly)
·

Clearing zero point calibration data

·

Yaw rate and acceleration sensor zero point calibration


Power steering ECU assembly Assist map writing
·

P/S warning light comes on

·

EPS control


(Click here)
·

Spiral cable sub-assembly

·

Spiral cable with sensor sub-assembly

·

Steering sensor


·

Steering angle neutral point (Initialize parking assist monitor system)

·

Steering angle setting


Parking assist monitor system (w/o Parallel Parking Assist Function) (Click here)for Initialization
(Click here)for Calibration
Suspension, tires, etc. Rear television camera assembly optical axis (Back camera position setting)
Rear television camera assembly
·

Parking assist monitor system initialization

·

Rear television camera assembly optical axis (Back camera position setting)


Blind spot monitor sensor Blind spot monitor beam axis inspection DTCs are output (Click here)
·

Power management control ECU

·

Certification ECU (smart key ECU assembly)

·

Steering lock ECU (steering lock actuator assembly)

·

Electrical key transmitter sub-assembly


Code registration (Engine immobiliser system)
·

Wireless door lock control system

·

Smart entry and start system

·

Hybrid control system start

·

Steering lock system


See Service Bulletin for the registration method.
·

No. 1 air conditioning radiator damper servo sub-assembly

·

No. 2 air conditioning radiator damper servo sub-assembly

·

No. 1 blower damper servo sub-assembly


Initialization servo motor (Air conditioning system) DTCs are output (Click here)
·

Door window regulator assembly

·

Power window regulator motor assembly

·

Door glass

·

Door glass run


Initialize power window control system
·

Auto up/down function

·

Jam protection function

·

Operation function after power switch is turned off

·

Key-linked function

·

Wireless transmitter-linked function


(Click here)
·

Sliding roof ECU (sliding roof drive gear sub-assembly)

·

Sliding roof glass sub-assembly

·

Sliding roof drive cable sub-assembly


Initialize sliding roof ECU (pulse sensor initial position setting)
·

Automatic slide open/close and tilt up/down function of sliding roof

·

Jam protection function

·

Operation function after power switch is turned off

·

Key-linked function

·

Wireless transmitter-linked function

·

Sliding roof open warning


(Click here)