Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM › from 2015.04
RM2040EQ_55Steering_014714STEERING COLUMN_0075005STEERING LOCK SYSTEMS
STEERING COLUMN STEERING LOCK SYSTEM DIAGNOSTIC TROUBLE CODE CHART
Steering Lock System
DTC No.
Detection Item
DTC Detection Condition
Note
Link
B2781
Open / Short in Steering Lock ECU
One of the following conditions is met (1-trip detection logic (Only output while a malfunction is present and the power switch is on (IG).)):
·
The steering lock/unlock position sensor is malfunctioning. (When both detection switches turn on, the system is determined to be malfunctioning.)
·
The steering lock motor activation circuit has a short circuit.
·
The steering lock motor activation circuit has an open circuit.
No confirmation operation is necessary (monitoring is continuous).
B2782
Power Source Control ECU Malfunction
Either condition is met (1-trip detection logic (Only output while a malfunction is present and the power switch is on (IG).)):
·
The steering lock motor activation command circuit has a short circuit.
·
The steering lock motor activation command circuit has an open circuit.
HINT:
If the power supply signal from the LIN communication line does not match the power supply signal from the direct line, the system is determined to be malfunctioning.
Perform a steering lock/unlock operation. (The steering locks when a door is opened with the shift lever in P and the power switch off. The steering unlocks when the power switch is turned on (ACC) or on (IG) while carrying the key.)
B2788
IG2 Signal Malfunction
Mismatch between the steering lock ECU IG2 input from the LIN communication system and from the direct line (1-trip detection logic (Only output while a malfunction is present and the power switch is on (IG).)).
No confirmation operation is necessary (monitoring is continuous).