This DTC is stored when the steering lock ECU detects an IG2 power supply malfunction.
The steering lock ECU is not connected to the CAN communication system. However, the steering lock ECU is connected to the certification ECU (smart key ECU assembly) via LIN communication and communicates with other components via CAN communication through the certification ECU (smart key ECU assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2788 | IG2 Signal Malfunction | Mismatch between the steering lock ECU IG2 input from the LIN communication system and from the direct line (1-trip detection logic (Only output while a malfunction is present and the power switch is on (IG).)). | ·
ECU-IG2 NO. 3 fuse ·
Steering lock ECU (Steering lock actuator assembly) ·
Harness or connector |
No confirmation operation is necessary (monitoring is continuous). |
| Vehicle Condition when Malfunction Detected | Fail-safe Function when Malfunction Detected |
|---|---|
| The steering cannot be locked or unlocked. For this reason, the hybrid control system cannot be started. | - |
| DTC No. | Data List Item | Active Test Item |
|---|---|---|
| B2788 | - | - |
When using the intelligent tester with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle and select "Manual" from the initial screen on the intelligent tester. Select "Key Code Registration" under model code.
The steering lock system uses LIN communication. First perform the inspections in "How to Proceed with Troubleshooting" to confirm that there are no communication malfunctions before proceeding with troubleshooting.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
After performing repairs, confirm that no DTCs are output again.
Click hereSteering>STEERING COLUMN>STEERING LOCK SYSTEM>DTC CHECK / CLEAR
When replacing the steering lock ECU (steering lock actuator assembly), registration must be performed (refer to Service Bulletin).
Make sure that there is no looseness at the locking part and the connecting part of the connector.
Disconnect the I24 steering lock ECU connector.
| *a | Front view of wire harness connector
(to Steering Lock ECU (Steering Lock Actuator Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I24-1 (GND) - Body ground | Always | Below 1 Ω |
Reconnect the I24 steering lock ECU connector.
| *a | Component with harness connected
(Steering Lock ECU (Steering Lock Actuator Assembly)) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I24-6 (IG2) - I24-1 (GND) | Power switch on (IG) | 11 to 14 V |
| I24-6 (IG2) - I24-1 (GND) | Power switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG