The occupant detection sensor (separate type front seat cushion pad) detects if the passenger seat is occupied and sends signals to the combination meter assembly. The front seat inner belt LH detects the passenger seat belt condition and sends signals to the combination meter assembly. After receiving the signals from the occupant detection sensor (separate type front seat cushion pad) and front seat inner belt LH, the seat belt warning light in the combination meter assembly will blink or go off.
The seat belt warning light on the combination meter assembly is used for both the driver seat and front passenger seat.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Data List.
Read the Data List according to the display on the intelligent tester.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| P-Seatbelt Buckle SW | Front passenger seat belt buckle switch signal | ON or OFF | OFF: Front passenger seat belt fastened
ON: Front passenger seat belt not fastened |
- |
| Tester Display |
|---|
| P-Seatbelt Buckle SW |
ON or OFF appears on the tester screen according to the front passenger seat belt condition.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I18 combination meter assembly connector.
Disconnect the N2 front seat inner belt assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I18-7 (P/SB) - N2-3 | Always | Below 1 Ω |
| I18-7 (P/SB) - Body ground | Always | 10 kΩ or higher |
| N2-2 - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Occupant Detection Sensor (Separate Type Front Seat Cushion Pad)) |
Remove the occupant detection sensor (separate type front seat cushion pad).
Click hereVehicle Interior>SEAT BELT>OCCUPANT DETECTION SENSOR>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 3 | Front passenger seat occupied | Below 100 Ω |
| 1 - 3 | Front passenger seat not occupied | 1 MΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component without harness connected
(Front Seat Inner Belt Assembly LH) |
Remove the front seat inner belt assembly LH.
Click hereVehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>REMOVAL
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N2-3 - B-1 | Always | Below 1 Ω |
| N2-2 - B-3 | Front passenger seat belt unfastened | Below 1 Ω |
| N2-2 - B-3 | Front passenger seat belt fastened | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG