Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER › from 2015.04
RM2040EQ _58 Vehicle Interior _014725 METER / GAUGE / DISPLAY _0075075 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 64718C 2.REMOVE LUGGAGE TRIM SERVICE HOLE COVER

Hide 3.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 62311B 4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 55317A 5.REMOVE INSTRUMENT SIDE PANEL RH

Hide 55431B 6.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

Hide 55670 7.REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55410C 8.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 83100 9.REMOVE COMBINATION METER ASSEMBLY

a.
E226433

Remove the 4 screws.


b.
E306607

Disengage the wire harness clamp.


c.

Disconnect the 2 connectors to remove the combination meter assembly.