1.REMOVE REAR SEAT CUSHION ASSEMBLY
72693
2.REMOVE REAR SEAT CUSHION LOCK HOOK
3.REMOVE REAR SEATBACK ASSEMBLY RH
64277C
4.REMOVE NO. 2 ROOM PARTITION COVER
5.REMOVE REAR SEATBACK ASSEMBLY LH
6.REMOVE REAR SIDE SEATBACK ASSEMBLY LH
7.REMOVE REAR SIDE SEATBACK ASSEMBLY RH
8.REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH
73480
9.DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH
73360C
10.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
Remove the bolt and disconnect the floor anchor of the rear No. 1 seat outer belt assembly RH.
73370C
11.DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt and disconnect the floor anchor of the rear No. 1 seat outer belt assembly LH.
62331A
12.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Disconnect the rear door opening trim weatherstrip RH.
62332A
13.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the rear door opening trim weatherstrip LH.
62471A
14.REMOVE ROOF SIDE INNER GARNISH RH
62472A
15.REMOVE ROOF SIDE INNER GARNISH LH
Use the same procedure as for the RH side.
73373
16.REMOVE REAR SEAT SHOULDER BELT COVER
Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.
Use the same procedure for the other 2 rear seat shoulder belt covers.
64330
17.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/o Rear Sunshade)
Disconnect the connector.
| *a | Protective Tape |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
Tape the tips of pliers before use.
Disengage the 5 guides.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
64330
18.REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Rear Sunshade)
| *a | Protective Tape |
Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
Tape the tips of pliers before use.
Disengage the guide.
Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.
73370C
19.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY LH
Remove the bolt.
Disengage the guide to remove the rear No. 1 seat outer belt assembly LH.
73360C
20.REMOVE REAR NO. 1 SEAT OUTER BELT ASSEMBLY RH
Use the same procedure as for the LH side.