DTC P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor) |
DTC P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0327 | The output voltage of the knock control sensor is less than 0.5 V for 1 second or more (1 trip detection logic). |
|
| P0328 | The output voltage of the knock control sensor is higher than 4.5 V for 1 second or more (1 trip detection logic). |
|

| ECM Terminal Name | Between KNK1 and EKNK |
| Tester Range | 1 V/DIV., 1 ms./DIV. |
| Condition | Engine speed maintained at 2500 rpm after warming up engine |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ VALUE USING GTS (KNOCK FEEDBACK VALUE) |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Put the engine in inspection mode (maintenance mode) (Click here).
Start the engine.
Warm up the engine.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Knock Feedback Value.
Read the value while driving the vehicle.
| Malfunction does not occur | Knock Feedback Value changes |
| Malfunctions occur | Knock Feedback Value does not change |
|
| ||||
| OK | ||
| ||
| 2.CHECK TERMINAL VOLTAGE (POWER SOURCE OF KNOCK CONTROL SENSOR) |
![]() |
Disconnect the knock control sensor connector.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Y1-2 - Y1-1 | Power switch on (IG) | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to Knock Control Sensor) |
|
| ||||
| OK | |
| 3.INSPECT KNOCK CONTROL SENSOR |
Inspect the knock control sensor (Click here).
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (KNOCK CONTROL SENSOR - ECM) |
Disconnect the knock control sensor connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Y1-2 - E28-123 (KNK1) | Always | Below 1 Ω |
| Y1-1 - E28-124 (EKNK) | Always | Below 1 Ω |
| Y1-2 or E28-123 (KNK1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||