DTC B278A Short to GND in Immobiliser System Power Source Circuit |
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
| B278A | A short to GND in the power supply of the transponder key amplifier of the power switch (VC5 - VC5) (1 trip detection logic*). |
| With the shift lever in P, the key held near the power switch and a hybrid control system start operation is performed by pressing and holding the power switch when the key battery is depleted. |
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
| Hybrid control system cannot be started when key battery is depleted by holding key near power switch and pressing and holding power switch with shift lever in P | - |
| DTC Code | Data List and Active Test |
| B278A | - |

| 1.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
![]() |
Using an oscilloscope, check the waveform.
| Item | Content |
| Tester Connection | I58-10 (VC5) - I58-6 (AGND) |
| Tool Setting | 2 V/DIV., 200 ms./DIV. |
| Condition | Power switch off, key not in cabin, within 30 seconds after power switch pressed |
| *a | Component with harness connected (Power Switch) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) - POWER SWITCH) |
Disconnect the I86 and I87 certification ECU (smart key ECU assembly) connectors.
Disconnect the I58 power switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I87-9 (VC5) - I58-10 (VC5) | Always | Below 1 Ω |
| I86-6 (AGND) - I58-6 (AGND) | Always | Below 1 Ω |
| I87-9 (VC5) or I58-10 (VC5) - Body ground | Always | 10 kΩ or higher |
| I86-6 (AGND) or I58-6 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) |
Reconnect the I86 and I87 certification ECU (smart key ECU assembly) connectors.
Reconnect the I58 power switch connector.
Measure the voltage according to the value(s) in the table below.

| *a | Component with harness connected (Certification ECU (Smart Key ECU Assembly)) | - | - |
| Tester Connection | Condition | Specified Condition |
| I87-9 (VC5) - I86-6 (AGND) | Power switch off, brake pedal not depressed, 30 seconds or more elapsed after driver door opened and then closed | Below 1 V |
|
| ||||
| OK | ||
| ||