Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY SMART UNIT

BATTERY SMART UNIT > INSTALLATION

for Preparation Click here



1. INSTALL BATTERY SMART UNIT

CAUTION:
Wear insulated gloves.



    A259414E01
  1. Install the battery smart unit to the HV battery with the bolt.
    Text in Illustration 
    *a
    Purple Label

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    Check color of the label.

  1. Install the wiring harness protector to the battery smart unit connector.

  1. Connect the battery smart unit connector.

    NOTICE:
    Make sure that the connector is connected securely.

  1. Engage the 2 claws to install the wiring harness protector cover to the battery smart unit connector.



2. INSTALL NO. 2 HYBRID VEHICLE BATTERY SHIELD PANEL

CAUTION:
Wear insulated gloves.

  1. Install the No. 2 hybrid vehicle battery shield panel to the HV battery with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Engage the 3 wire harness clamps to the No. 2 hybrid vehicle battery shield panel.

  1. Connect the 2 battery smart unit connectors.

    NOTICE:
    Make sure that the connector is connected securely.



3. INSTALL NO. 1 HV BATTERY LH COVER BRACKET


    A332118E01
  1. Install the No. 1 HV battery LH cover bracket to the HV battery with the battery cover lock striker, then push the button to lock it.
    Text in Illustration 
    *1
    Battery Cover Lock Striker
    *a
    Button
    *b
    Push

  1. Install the 2 nuts to the No. 1 HV battery LH cover bracket.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }



4. INSTALL REAR SEATBACK ASSEMBLY
  1. Lift the rear seatback assembly LH.



    B284996
  1. Engage the guide and claw to install the No. 2 room partition cover.

  1. Connect the rear seat outer belt to the rear seat center shoulder belt guide.

  1. Lift the rear seatback assembly RH.



5. INSTALL SERVICE PLUG GRIP
(Click here)