DTC C1345/66 Linear Solenoid Valve Offset Learning Undone |
DTC C1368/67 Linear Solenoid Valve Offset Malfunction |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| C1345/66 | - | Linear valve offset learning undone. | Perform linear valve offset learning and check for DTCs. If no DTCs are output again, the valve is normal. |
| C1368/67 | - | Offset learned value out of specification. |
|
| 1.CHECK DTC |
Clear the DTCs (Click here).
Turn the power switch off.
Turn the power switch on (IG).
Check the DTCs (electronically controlled brake system and hybrid control system) that are output (Click here for the electronically controlled brake system, or Click here for the hybrid control system).
| Result | Proceed to |
| DTCs (except C1345/66, C1368/67 and hybrid control system DTC) are not output. | A |
| Hybrid control system DTC is output. | B |
| DTCs (except C1345/66 and/or C1368/67) are output. | C |
|
| ||||
|
| ||||
| A | |
| 2.PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE |
Turn the power switch off.
Perform initialization and calibration of the linear solenoid valve (Click here).
| NEXT | |
| 3.RECONFIRM DTC |
Turn the power switch off.
Clear the DTCs (Click here).
Turn the power switch on (IG).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTCs C1345/66 and C1368/67 are not output. | A |
| DTCs C1345/66 and/or C1368/67 are output (for LHD). | B |
| DTCs C1345/66 and/or C1368/67 are output (for RHD). | C |
|
| ||||
|
| ||||
| A | ||
| ||