BRAKE PEDAL STROKE SENSOR (for RHD) > INSTALLATION |
| 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT |
Check the brake pedal height.
Turn back the carpet.
Turn back the dash panel insulator assembly from the slit provided on the dash panel insulator assembly.
![]() |
Measure the shortest distance between the brake pedal pad surface and asphalt sheet.
| *1 | Stop Light Switch Assembly |
| *2 | Asphalt Sheet |
| *a | Brake Pedal Height |
Adjust the push rod length.
Remove the stop light switch assembly (Click here).
Remove the brake booster with master cylinder assembly (Click here).
![]() |
Loosen the lock nut and adjust the push rod length shown in the illustration by turning the brake master cylinder push rod clevis to achieve the correct length.
| *1 | Lock Nut |
| *2 | Brake Master Cylinder Push Rod Clevis |
| *a | Push Rod Length |
Tighten the lock nut.
Install the brake booster with master cylinder assembly (Click here).
Install the stop light switch assembly (Click here).
After adjusting the pedal height, check the brake pedal free play.
| 2. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY |
When installing a new brake pedal stroke sensor assembly:
![]() |
Install a new brake pedal stroke sensor assembly with the 2 bolts.
| *1 | Brake Pedal Stroke Sensor Assembly Lever |
| *a | Brake Pedal Groove |
Firmly depress the brake pedal and break the brake pedal stroke sensor assembly lever set pin.
Remove the broken lever set pin.
Connect the connector to the brake pedal stroke sensor assembly.
When reusing the brake pedal stroke sensor assembly:
![]() |
Temporarily install the brake pedal stroke sensor assembly with the 2 bolts.
| *1 | Brake Pedal Stroke Sensor Assembly Lever |
| *a | Brake Pedal Groove |
Connect the connector to the brake pedal stroke sensor assembly.
| 3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 4. ADJUST BRAKE PEDAL STROKE SENSOR ASSEMBLY |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Chassis / ABS/VSC/TRC / Data List "Stroke Sensor".
![]() |
Read the stroke sensor value in the Data List, and turn the brake pedal stroke sensor assembly slowly to the right or left to adjust the output voltage so that it is within the following range.
Tighten the 2 bolts.
Turn the intelligent tester off.
Turn the power switch off.
Disconnect the intelligent tester.
| 5. CHECK AND CLEAR DTC |
| 6. PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE |