Home › Suspension › REAR SUSPENSION › REAR LOWER ARM

REAR LOWER ARM > REMOVAL

for Preparation Click here


HINT:
The rear No. 2 suspension arm assembly RH can be removed directly from the vehicle.



1. REMOVE REAR WHEELS


2. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
(Click here)


3. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH


    C240571
  1. Remove the bolt and nut, and separate the rear No. 2 suspension arm assembly RH (outer side) from the rear axle carrier sub-assembly.

    NOTICE:
    When removing the bolt, keep the nut from rotating.



4. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY RH


    C244154
  1. Remove the bolt and rear No. 2 suspension arm assembly RH from the rear suspension member sub-assembly.



5. REMOVE REAR SUSPENSION MEMBER SUB-ASSEMBLY
(Click here)


6. REMOVE REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    C241263
  1. Remove the bolt and rear No. 2 suspension arm assembly LH from the rear suspension member sub-assembly.



7. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    C241262
  1. Remove the bolt and rear No. 1 suspension arm assembly from the rear suspension member sub-assembly.



8. REMOVE REAR NO. 1 SUSPENSION ARM ASSEMBLY RH

HINT:
Perform the same procedure as for the LH side.