METER / GAUGE SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| |||||
| 3.CHECK CAN COMMUNICATION SYSTEM* |
Check if CAN communication DTCs are output (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| DTCs are output. | B |
|
| ||||
| |||||
| 4.CHECK FOR DTC* |
Check if meter/gauge system DTCs are output (Click here).
| Result | Proceed to |
| DTCs are not output. | A |
| DTCs are output. | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOM CONFIRMATION |
| |||||
| 6.SYMPTOM SIMULATION |
| |||||
| 7.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| |||||
| 8.CIRCUIT INSPECTION |
| |||||
| 9.REPAIR OR REPLACE |
| |||||
| 10.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|