Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
Use the following procedure to troubleshoot the rear view monitor system.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT AUXILIARY BATTERY VOLTAGE
    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.


    NEXT


    3.PROBLEM SYMPTOM CONFIRMATION

      Result:
      Result
      Proceed to
      Symptom does not occur
      A
      Symptom occurs
      B



    B.
    Go to step 5
    A


    4.SYMPTOM SIMULATION

      NEXT


      5.CHECK IF SAME SYMPTOM APPEARS IN AUDIO AND VISUAL SYSTEM
      1. Refer to the Audio and Visual System (Click here).

        Result:
        Result
        Proceed to
        Symptom does not appear
        A
        Symptom appears (follow the audio and visual system symptom table to perform troubleshooting)
        B



      B.
      GO TO AUDIO AND VISUAL SYSTEM (Click here)
      A


      6.PROBLEM SYMPTOMS TABLE
      1. Refer to Problem Symptoms Table (Click here).

        Result:
        Result
        Proceed to
        Fault is not listed in Problem Symptoms Table
        A
        Fault is listed in Problem Symptoms Table
        B



      B.
      Go to step 8
      A


      7.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM
      1. Terminals of ECU (Click here)


      NEXT


      8.ADJUST, REPAIR OR REPLACE

        NEXT


        9.CONFIRMATION TEST

          NEXT

          END