REAR VIEW MONITOR SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Ask the customer about the problems and the conditions at the time the malfunction occurred to make sure the problem symptom was not temporarily caused by radio waves in the surrounding environment.
| Problem Symptom | Cause |
Both of the following conditions are met:
| The display may be temporarily distorted when the vehicle is close to an object that transmits radio waves, such as a telecommunication tower, an airport or a truck equipped with a transceiver. |
| |||||
| 3.INSPECT AUXILIARY BATTERY VOLTAGE |
Measure the auxiliary battery voltage with the power switch off.
| |||||
| 4.CHECK FOR DTC |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
Recheck for DTCs. Try to reproduce the DTCs by simulating the conditions indicated by the DTCs (Click here).
| Result | Proceed to |
| No DTCs are output | A |
| DTCs are output | B |
|
| ||||
| |||||
| 5.PROBLEM SYMPTOM CONFIRMATION |
| Result | Proceed to |
| Symptom does not occur | A |
| Symptom occur | B |
|
| ||||
| |||||
| 6.SYMPTOM SIMULATION |
Refer to Symptom Simulation (Click here).
| |||||
| 7.CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM |
Refer to Audio and Visual System (Click here).
| Result | Proceed to |
| Symptom does not appear | A |
| Symptom appears | B |
|
| ||||
| |||||
| 8.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 9.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM |
Refer to Terminals of ECU (Click here).
| |||||
| 10.ADJUST, REPAIR OR REPLACE |
| |||||
| 11.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|