HYBRID TRANSAXLE SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT FLUID PRESSURE OF OIL PUMP |
Remove the front fender apron seal LH.
![]() |
Remove the fluid pump cover plug and O-ring from the hybrid vehicle transaxle assembly.
![]() |
Install the SST to the hybrid vehicle transaxle assembly.
Put the engine in inspection mode (Click here).
Measure the fluid pressure.
| Engine Speed | Transaxle Fluid Pressure |
| 900 rpm | 9.8 kPa (0.1 kgf/cm2, 1.4 psi) or more |
Remove the SST from the hybrid vehicle transaxle assembly.
Install a new O-ring and fluid pump cover plug to the hybrid vehicle transaxle assembly.
Install the front fender apron seal LH.