Home › Engine / Hybrid System › 2AR-FXE FUEL › FUEL INJECTOR

FUEL INJECTOR > REMOVAL

for Preparation Click here


HINT:
Perform "Inspection After Repair" after replacing the fuel injector assembly .
  1. w/ EGR System: (Click here)
  2. w/o EGR System: (Click here)



1. PRECAUTION

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).



2. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL


5. DISCONNECT INTAKE MANIFOLD
(Click here)


6. DISCONNECT FUEL TUBE SUB-ASSEMBLY


    A259299
  1. Remove the No. 1 fuel pipe clamp.



    A259300E01
  1. Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
    Text in Illustration 
    *1
    Fuel Pipe
    *2
    Fuel Tube Connector
    *3
    Nylon Tube
    *4
    O-ring
    *5
    Retainer
    V100135
    Pinch
    V100136
    Pull

    NOTICE:
    1. Check for foreign matter on the fuel tube around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel pipe.
    2. Do not use any tools to separate the fuel tube connector and fuel pipe.
    3. Do not forcefully bend, kink or twist the nylon tube.
    4. Keep the fuel tube connector and fuel pipe free from foreign matter.
    5. If the fuel tube connector and fuel pipe are stuck, push and pull to release them.
    6. Put the fuel tube connector and fuel pipe in plastic bags to prevent damage and contamination.

  1. Remove the fuel tube sub-assembly from the fuel hose clamp.



7. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY


    A259321
  1. Disconnect the 4 fuel injector connectors.

  1. Remove the 2 bolts, and then remove the fuel delivery pipe together with the 4 fuel injectors.

    NOTICE:
    Be careful not to drop the fuel injectors when removing the fuel delivery pipe.



    A259322
  1. Remove the 2 fuel delivery spacers from the cylinder head.

  1. Remove the 4 injector vibration insulators from the cylinder head.



8. REMOVE FUEL INJECTOR ASSEMBLY


    A259303E01
  1. Pull the 4 fuel injectors out of the fuel delivery pipe.

  1. Remove the O-ring from each fuel injector.

  1. For reinstallation, attach a tag or label to each injector shaft.

    NOTICE:
    Prevent entry of foreign matter by covering the fuel injectors with plastic bags.