REAR AXLE CARRIER > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD) |
| 3. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD) |
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.
![]() |
Remove the 10 bolts and front outer cowl top panel sub-assembly.
| 4. DISABLE BRAKE CONTROL (for LHD) |
Wait at least 2 minutes after turning the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 5. DISABLE BRAKE CONTROL (for RHD) |
Wait at least 2 minutes after turning the power switch off.
![]() |
Disconnect the reservoir level switch connector with the parking brake applied.
Disconnect the cable from the negative (-) auxiliary battery terminal (Click here).
Depress the brake pedal 40 times or more to return all the fluid in the accumulator back to the reservoir.
Check that the brake pedal can not be further depressed.
Release the parking brake.
| 6. REMOVE REAR WHEEL |
| 7. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY |
![]() |
Remove the bolt and separate the rear flexible hose from the rear shock absorber assembly.
Remove the 2 bolts, and separate the rear disc brake caliper assembly.
| 8. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG |
Remove the parking brake shoe adjusting hole plug.
| 9. REMOVE REAR DISC |
![]() |
Put matchmarks on the rear disc and the rear axle hub.
| *a | Matchmark |
![]() |
Release the parking brake and remove the rear disc.
| 10. DISCONNECT SKID CONTROL SENSOR WIRE |
![]() |
Using a screwdriver, disconnect the connector from the rear speed sensor.
| 11. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY |
![]() |
Remove the 4 bolts and the rear axle hub and bearing assembly.
| 12. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY (for RH Side) |
| 13. SEPARATE REAR STRUT ROD ASSEMBLY |
![]() |
Use a jack and wooden block to support the rear axle carrier sub-assembly.
| *1 | Jack |
| *2 | Wooden Block |
Remove the bolt, nut and separate the rear strut rod assembly (rear side) from the rear axle carrier sub-assembly.
| 14. SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY |
![]() |
Remove the bolt, nut and separate the rear No. 2 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.
| 15. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY |
![]() |
Remove the bolt, nut and separate the rear No. 1 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.
| 16. REMOVE REAR AXLE CARRIER SUB-ASSEMBLY |
![]() |
Remove the 2 bolts, 2 nuts and rear axle carrier sub-assembly from the rear shock absorber.