Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Engine Hood Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The engine hood courtesy switch is installed together with the hood lock. This switch turns on when the engine hood is closed and turns off when the engine hood is opened.

WIRING DIAGRAM


B289668E02


INSPECTION PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. According to the display on the intelligent tester, read the Data List.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Hood Courtesy SW
    Engine hood courtesy switch/ON or OFF
    ON: Engine hood closed
    OFF: Engine hood open
    -

    OK:
    The indicator on the intelligent tester switches between ON and OFF in accordance with the engine hood courtesy switch (hood lock assembly) status.



NG
Go to step 2
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)  

2.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Remove the main body ECU (multiplex network body ECU) (Click here).


    B220554E14


Text in Illustration 
*a
Component without harness connected
(Instrument Panel Junction Block Assembly)
-
-
  1. Disconnect the 3D instrument panel junction block assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3D-25 - MB-20 (HCTY)
    Always
    Below 1 Ω



NG
REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (Click here)
OK


3.INSPECT ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY)


  1. Remove the hood lock assembly (Click here).


    B281400E01


    Text in Illustration 
    *A
    for LHD
    *B
    for RHD
    *1
    Opened
    *2
    Locked
    *a
    Component without harness connected
    (Engine Hood Courtesy Switch (Hood Lock Assembly))
    -
    -

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 - 2
    Opened
    10 kΩ or higher
    1 - 2
    Locked
    Below 1 Ω



NG
REPLACE ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY - ENGINE HOOD COURTESY SWITCH - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A2-1 - 3D-25
    Always
    Below 1 Ω
    A2-1 - Body ground
    Always
    10 kΩ or higher
    A2-2 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)