Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR (for Rear Side)

ULTRASONIC SENSOR (for Rear Side) > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER ASSEMBLY
(Click here)


2. REMOVE NO. 2 LUGGAGE ROOM WIRE

HINT:
Use the same procedure for all connectors.



    E301648
  1. Disengage the clamp.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.

  1. Disconnect the connector to remove the No. 2 luggage room wire.



3. REMOVE ULTRASONIC SENSOR CLIP

HINT:
Use the same procedure for all ultrasonic sensor clips.



    E301649
  1. Disengage the 4 claws to remove the ultrasonic sensor clip.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



4. REMOVE NO. 1 ULTRASONIC SENSOR

HINT:
Use the same procedure for all No. 1 ultrasonic sensors.



    E301650
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.



5. REMOVE NO. 1 ULTRASONIC SENSOR RETAINER

HINT:
Use the same procedure for all No. 1 ultrasonic sensor retainers.



    E301651
  1. Disengage the 2 claws to remove the No. 1 ultrasonic sensor retainer from the rear bumper assembly.

    HINT:
    This illustration is for the LH side. The orientation for the RH side is the opposite of the LH side.