ENGINE HOOD COURTESY SWITCH > INSTALLATION |
| 1. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) (for LHD) |
![]() |
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
Connect the connector.
| 2. INSTALL ENGINE HOOD COURTESY SWITCH (HOOD LOCK ASSEMBLY) (for RHD) |
![]() |
Apply MP grease to the sliding areas of the lock.
Connect the hood lock control cable assembly.
Install the hood lock assembly with the 2 bolts and hood lock bolt.
Connect the connector.
| 3. INSTALL FRONT BUMPER ASSEMBLY |
| 4. INSPECT HOOD SUB-ASSEMBLY |
Check that the clearance measurements of areas *a through *f are within each standard range.

| Area | Measurement | Area | Measurement |
| *a | 5.5 to 9.5 mm (0.217 to 0.374 in.) | *b | -0.8 to 3.2 mm (-0.0315 to 0.126 in.) |
| *c | 8.7 to 12.7 mm (0.345 to 0.500 in.) | *d | 2.8 to 6.8 mm (0.110 to 0.268 in.) |
| *e | 2.3 to 5.3 mm (0.0906 to 0.209 in.) | *f | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| 5. ADJUST HOOD SUB-ASSEMBLY |