EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
Inspect the hoses and gaskets for scratches, cracks or air/oil leaks from the connecting parts.
| 2. INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM |
Connect the intelligent tester to the DLC3.
Put the engine in inspection mode (maintenance mode) (Click here).
![]() |
Start the engine and disconnect the fuel vapor feed hose from the purge VSV.
| *1 | Retainer |
| *2 | Fuel Tube Connector |
| *3 | Pipe |
| *4 | O-ring |
| *a | Pull |
Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for Evap Control.
Check that vacuum occurs at the purge VSV port.
If vacuum does not occur, check the following items:
![]() |
Exit Active Test mode and reconnect the fuel vapor feed hose.
| *1 | Retainer |
| *a | Push |
Enter the following menus: Powertrain / Engine / Data List / EVAP Purge VSV.
Warm up the engine and drive the vehicle.
Confirm that the purge VSV opens.
If the result is not as specified, replace the purge VSV, wire harness or ECM.