Home › Steering › STEERING COLUMN › STEERING LOCK SYSTEM

DTC    B2788    IG2 Signal Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when the steering lock ECU detects an IG2 power supply malfunction.

HINT:
The steering lock ECU is not connected to the CAN communication system. However, the steering lock ECU is connected to the certification ECU (smart key ECU assembly) via LIN communication and communicates with other components via CAN communication through the certification ECU (smart key ECU assembly).


DTC No.
Detection Condition
Trouble Area
DTC Output Confirmation Operation
B2788
Mismatch between the steering lock ECU IG2 input from the LIN communication system and from the direct line (1-trip detection logic*).
  1. ECU-IG2 NO. 3 fuse
  2. Steering lock ECU (Steering lock actuator assembly)
  3. Harness or connector
No confirmation operation is necessary (monitoring is continuous).
  1. *: Only output while a malfunction is present and the power switch is on (IG).

Vehicle Condition and Fail-safe Function when Malfunction Detected 
Vehicle Condition when Malfunction Detected
Fail-safe Function when Malfunction Detected
The steering cannot be locked or unlocked. For this reason, the hybrid control system cannot be started.
-

Related Data List and Active Test Items 
DTC No.
Data List Item
Active Test Item
B2788
-
-

WIRING DIAGRAM


C240290E04


INSPECTION PROCEDURE

NOTICE:
  1. When using the intelligent tester with the power switch off, perform either of the following: 1) Turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins, or 2) connect the intelligent tester to the vehicle and select "Manual" from the initial screen on the intelligent tester. Select "Key Code Registration" under model code.
  2. The steering lock system uses LIN communication. First perform the inspections in "How to Proceed with Troubleshooting" to confirm that there are no communication malfunctions before proceeding with troubleshooting (Click here).
  3. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  4. After performing repairs, confirm that no DTCs are output again (Click here).
  5. When replacing the steering lock ECU (steering lock actuator assembly), registration must be performed (refer to Service Bulletin).

1.INSPECT STEERING LOCK ECU (POWER SOURCE MODE SIGNAL)
  1. Make sure that there is no looseness at the locking part and the connecting part of the connector.

  1. Disconnect the I24 steering lock ECU connector.



    C157850E40
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I24-1 (GND) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Steering Lock ECU (Steering Lock Actuator Assembly))

  1. Reconnect the I24 steering lock ECU connector.



    C157849E32
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    I24-6 (IG2) - I24-1 (GND)
    Power switch on (IG)
    11 to 14 V
    I24-6 (IG2) - I24-1 (GND)
    Power switch off
    Below 1 V

    Text in Illustration 
    *a
    Component with harness connected
    (Steering Lock ECU (Steering Lock Actuator Assembly))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE STEERING LOCK ACTUATOR ASSEMBLY (Click here)