2 or more ECUs and/or sensors do not appear on the intelligent tester "Communication Bus Check" screen.
| One side of CAN branch line is open, or output signals are incomplete.
- Power management control ECU
- ECM
- Main body ECU (Multiplex network body ECU)
- Combination meter assembly
- Brake booster with master cylinder assembly (Skid control ECU)
- Steering sensor
- Clearance warning ECU assembly*1
- Power steering ECU assembly
- Airbag sensor assembly
- Air conditioning amplifier assembly
- Smart key ECU assembly (Certification ECU)
- Radio and display receiver assembly
|