Home › Brake › PARKING BRAKE › PARKING BRAKE PEDAL (for LHD)

PARKING BRAKE PEDAL (for LHD) > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).



2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    A259067
  1. Disengage the claw to remove the luggage trim service hole cover.



3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



4. REMOVE SHIFT LEVER SUPPORT
(Click here)


5. REMOVE NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY


    B279162
  1. Disengage the clamp.

  1. Remove the bolt.

  1. Disconnect the connector and remove the No. 1 indoor electrical key antenna assembly.

    NOTICE:
    Be careful when removing the indoor electrical key antenna assembly. If the antenna is dropped, replace it with a new one.



6. REMOVE FLOOR CARPET BRACKET RH


    E227159
  1. Remove the 2 clips.

  1. Disengage the 2 guides to remove the floor carpet bracket RH.



7. REMOVE AIRBAG SENSOR ASSEMBLY
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

  1. Turn back the carpet.



    B278814
  1. Disconnect the connectors from the airbag sensor assembly as shown in the illustration.

    NOTICE:
    When disconnecting any airbag connector, take care not to damage the airbag wire harness.

  1. Remove the 3 bolts and airbag sensor assembly.



8. REMOVE POWER MANAGEMENT CONTROL ECU


    B293079
  1. Disconnect the 4 connectors.



    B293080
  1. Remove the 2 nuts and power management control ECU.



9. LOOSEN ADJUSTING NUT


    C237832E01
  1. Remove the lock nut and loosen the adjusting nut.
    Text in Illustration 
    *1
    Lock Nut
    *2
    Adjusting Nut



10. SEPARATE NO. 4 PARKING BRAKE CABLE ASSEMBLY


    C240122E01
  1. Separate the No. 4 parking brake cable assembly from the parking brake control pedal assembly as shown in the illustration.
    Text in Illustration 
    *a
    Turn
    *b
    Hold



11. REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
  1. Turn back the floor carpet.



    C240125
  1. Remove the clip from the No. 1 parking brake cable assembly.

  1. Remove the bolt and 2 nuts, and separate the No. 1 parking brake cable assembly.



    C237835
  1. Disconnect the parking brake switch connector.



    C237836
  1. Remove the bolt, 2 nuts and parking brake control pedal assembly.