FRAME WIRE > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
| 3. REMOVE FUEL TANK ASSEMBLY |
| 4. SEPARATE REAR SEATBACK ASSEMBLY RH |
Fold down the rear seatback assembly RH.
| 5. REMOVE REAR SIDE SEATBACK ASSEMBLY RH |
Disconnect the rear seat outer belt from the rear seat shoulder belt guide RH.
![]() |
Remove the bolt.
Disengage the hook and remove the rear side seatback assembly RH.
| 6. REMOVE ROOM PARTITION BOARD LH |
![]() |
Using a clip remover, remove the clip.
Disengage the 5 claws and clip, and remove the room partition board LH.
| 7. REMOVE NO. 2 FRONT FLOOR FOOTREST COVER RH |
![]() |
Remove the 6 clips and No. 2 front floor footrest cover RH.
| 8. REMOVE NO. 4 HYBRID BATTERY SHIELD PANEL |
![]() |
Using the service plug grip, remove the battery cover lock striker.
| *1 | Service Plug Grip |
| *2 | Battery Cover Lock Striker |
| *a | Button |
| *b | Projection |
| *c | Turn |
![]() |
Remove the bolt, 2 nuts and No. 4 hybrid battery shield panel from the HV battery.
| 9. REMOVE NO. 4 FLOOR WIRE |
![]() |
Disconnect the 2 connectors.
Disconnect the shielded wire ground.
![]() |
Disconnect the wire harness clamp and connector.
![]() |
Disengage the 3 claws and push the frame wire out from the floor panel.
![]() |
Disconnect the 2 wire harness clamps.
![]() |
Disconnect the 2 wire harness clamps and connector.
| *A | for LHD: |
| *B | for RHD: |
Remove the 2 nuts.
![]() |
Remove the bolt and disconnect the clamp.
![]() |
Remove the 2 bolts.
Remove the 4 nuts.

Disconnect the 2 clamps and remove the No. 4 floor wire.
